Camshaft adjuster unit
Detailed list of the various versions
Select below the options you want to use to filter the list of parts concerned on the right-hand side of the screen.
Other
Position
Camshaft adjuster unit
INLET / CYLINDER 1-2-3
Camshaft adjuster
INLET / CYLINDER 4-5-6
INLET / CYLINDER 1-2-3
EXHAUST / CYLINDER 1-2-3
INLET / CYLINDER 4-5-6
EXHAUST / CYLINDER 4-5-6
2 Versions available for this part
18.77 X 1.78 MM
6 X 12 MM
2 Versions available for this part
2 Versions available for this part
In the same category:
CYLINDER 4-5-6
CYLINDER 1-2-3
CYLINDER 1-2-3
CYLINDER 4-5-6
INLET / CYLINDER 4-5-6
INLET / CYLINDER 1-2-3
EXHAUST / CYLINDER 1-2-3
EXHAUST / CYLINDER 4-5-6
ENGINE OIL DRAIN VALVE
DEEP OIL PAN KIT 2 LITER STAINLESS STEEL
2 LITRES
STAINLESS STEEL OIL PAN DEFLECTOR KIT
OIL COOLER THERMOSTAT
Kn sports air filter
Kn air filter cleaner
Servicing oil for kn air filter
Direct intake kit
Engine oil mobil1 0w40
1 LITRES
GULF OIL FORMULA G 5W40
1 LITRES
Engine oil mobil1 0w40
5 LITRES
GULF FORMULA G 5W40 OIL
5 LITRES
GULF FLAT OIL 4 - 6 5W50
4.5 LITRES
Fuel tank cap
PLASTIC
OVERHAUL KIT
TENSIONING ROLLER KIT
HIRE OF EXTRACTION TOOL TO REPLACE IMS INTERMEDIATE SHAFT BEARING
CONTACT US FOR A PRICE
Modification kit for intermediate shaft lubrication
REPAIR KIT FOR INTERMEDIATE SHAFT BEARING IMS
CAN BE FITTED WITHOUT REMOVING THE ENGINE BUT IT REQUIRES SPECIAL TOOLS (P544966 FOR PURCHASE OR P544968 FOR HIRE)
REPAIR KIT FOR INTERMEDIATE SHAFT BEARING IMS
FITTING ENTAILS REMOVAL OF THE ENGINE
Tool kit for replacing ims bearings
Set of seals
Gasket set
LINE BUSHES (FULL SET)
INTERIOR MEASUREMENT -0.25 / EXTERIOR MEASUREMENT STANDARD / COMPLETE KIT FOR A VEHICLE
LINE BUSHES (FULL SET)
INTERIOR MEASUREMENT -0.50 / EXTERIOR MEASUREMENT STANDARD
CONROD BEARINGS SET
REPAIR MEASUREMENT -0.25 MM / COMPLETE KIT
CONROD BEARINGS SET
REPAIR MEASUREMENT -0.50 MM / COMPLETE KIT
HIGH STRENGTH FORGED CONNECTING RODS (FULL SET)
CARRILLO MAKE / NON-REINFORCED CONNECTING ROD SCREWS FOR ENGINE SPEEDS NOT EXCEEDING 8,500 RPM
HIGH STRENGTH FORGED CONNECTING RODS (FULL SET)
CARRILLO MAKE / NON-REINFORCED CONNECTING ROD SCREWS FOR ENGINE SPEEDS NOT EXCEEDING 8,500 RPM
POLYURETHANE INSERT FOR ENGINE MOUNTING
POLYURETHANE RESILIENT MOUNT FOR ENGINE CONSOLE
Other diagrams in the family « Engine and fuel feed »
Engine and fuel feed
