Water hose for 997-1 / 911 Carrera • 2007 • 997 c2s • Cabrio • Manual gearbox, 6 speed
-
Reference :
P97516
-
Series selected :
997-1 / 911 Carrera
-
Model selected :
2007 - 997 c2s
-
Section :
Engine and fuel feed > Front water radiator / front radiator fan / front radiator duct
-
Recommended :
1
-
Weight :
0.206 kg
-
Position :
LEFT RETURN
-
Other :
RETURN
Other versions available for the part:
Water hose
RETURN / LEFT RETURN
Water hose
RETURN / RIGHT RETURN
2 Versions available for this part
2 Versions available for this part
2 Versions available for this part
6 MM
2 Versions available for this part
2 Versions available for this part
2 Versions available for this part
2 Versions available for this part
2 Versions available for this part
In the same category:
INLET / INLET
RETURN / LEFT
RETURN
INLET
INLET
INLET
RETURN
INLET / LEFT INTAKE
RIGHT RETURN
RIGHT INTAKE
LEFT RETURN
LEFT
RIGHT
INLET / RIGHT INTAKE
INLET / LEFT INTAKE
LEFT
RIGHT
LEFT
RIGHT
ENGINE OIL DRAIN VALVE
DEEP OIL PAN KIT 2 LITER STAINLESS STEEL
2 LITRES
STAINLESS STEEL OIL PAN DEFLECTOR KIT
B&B OIL COOLER FAN KIT 1965-2009
OIL COOLER THERMOSTAT
Kn sports air filter
Kn air filter cleaner
Servicing oil for kn air filter
Direct intake kit
Engine oil mobil1 0w40
1 LITRES
GULF OIL FORMULA G 5W40
1 LITRES
Engine oil mobil1 0w40
5 LITRES
GULF FORMULA G 5W40 OIL
5 LITRES
GULF FLAT OIL 4 - 6 5W50
4.5 LITRES
Fuel tank cap
PLASTIC
OVERHAUL KIT
OVERHAUL KIT
TENSIONING ROLLER KIT
EXTRACTION TOOL TO REPLACE IMS INTERMEDIATE SHAFT BEARING
Modification kit for intermediate shaft lubrication
REPAIR KIT FOR INTERMEDIATE SHAFT BEARING IMS
CAN BE FITTED WITHOUT REMOVING THE ENGINE BUT IT REQUIRES SPECIAL TOOLS (P544966 FOR PURCHASE OR P544968 FOR HIRE)
REPAIR KIT FOR INTERMEDIATE SHAFT BEARING IMS
FITTING ENTAILS REMOVAL OF THE ENGINE
Tool kit for replacing ims bearings
Set of seals
Gasket set
CONROD BEARINGS SET
REPAIR MEASUREMENT -0.25 MM / COMPLETE KIT
CONROD BEARINGS SET
REPAIR MEASUREMENT -0.50 MM / COMPLETE KIT
HIGH STRENGTH FORGED CONNECTING RODS (FULL SET)
CARRILLO MAKE / NON-REINFORCED CONNECTING ROD SCREWS FOR ENGINE SPEEDS NOT EXCEEDING 8,500 RPM
HIGH STRENGTH FORGED CONNECTING RODS (FULL SET)
CARRILLO MAKE / REINFORCED CONNECTING ROD SCREWS STANDING UP TO ENGINE SPEEDS OF OVER 8,500 RPM
GENERATION EV1/EV6 INJECTOR CONNECTION KIT
Other diagrams in the family « Engine and fuel feed »
Engine and fuel feed
